2005 Toyota MR2 C65MFACTORY OEM SERVICE PROCEDURE

Throttle Body (M/T): Removal

  1. DRAIN ENGINE COOLANT 
  2. REMOVE SUSPENSION UPPER BRACE 
  3. DISCONNECT VSV FOR EVAP FROM AIR CLEANER HOSE 
  4. REMOVE AIR CLEANER HOSE 
  5. DISCONNECT ACCELERATOR CABLE 
  6. REMOVE THROTTLE BODY 
    1. Disconnect the throttle position sensor connector.
    2. Disconnect the IAC valve connector.
    3. Disconnect the PCV hose from the throttle body.
      Fig 1: Disconnecting Throttle Position Sensor Connector, IAC Valve Connector And PCV Hose
      G02631038Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the 2 water bypass hoses from the throttle body.
    5. Remove the 2 bolts, 2 nuts, throttle body and 2 gaskets from the intake manifold.
    6. Remove the 2 bolts and accelerator cable bracket from the throttle body.
    Fig 2: Identifying Bolts, Nuts And Water Bypass Hoses
    G02631039Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.