Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota MR2 C65MFACTORY OEM SERVICE PROCEDURE
Inspection Procedure
- Check A/C compressor.
PREPARATION:
- Check the tension of the compressor drive belt (See DRIVE BELT ).
- Check if the compressor does not lock during operation with the engine started, and the blower switch and A/C switch ON.
- NG: Adjust drive belt tension or repair compressor (See DRIVE BELT ).
- OK: Go to next step.
- Check A/C compressor lock sensor (See COMPRESSOR AND MAGNETIC CLUTCH
).
Reference: INSPECTION USING OSCILLOSCOPE
During cranking or idling, check the waveform between terminals LCKI and E1 of the ECM connector.
HINT:
The correct waveform appears as shown in Fig 1.
- NG: Replace compressor lock sensor (See COMPONENTS ).
- OK: Go to next step.
- Check magnetic clutch relay (Marking: A/C COMP) (See INSPECTION
).
- NG: Replace magnetic clutch relay (See MAGNETIC CLUTCH RELAY ).
- OK: Go to next step.
- Check harness and connectors between A/C compressor lock sensor and ECM (See HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE
).
- NG: Repair or replace harness or connector.
- OK: Replace ECM (See HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE ).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
