Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota MR2 C56FACTORY OEM SERVICE PROCEDURE
Monitor Strategy
MONITOR STRATEGY SPECIFICATION TABLE
| Related DTCs | P0860: No communication to/from transmission control ECU |
| Required sensors/ components (Main) | Transmission ECU and ECM |
| Required sensors/ components (Related) | - |
| Frequency of operation | Continuous |
| Duration | Condition met for 7 times |
| MIL operation | Immediate |
| Sequence of operation | None |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.