Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE
Heated Oxygen Sensor: Inspection
- INSPECT HEATER RESISTANCE OF HEATED OXYGEN SENSORS
- Disconnect the oxygen sensor connector.
- Using an ohmmeter, measure the resistance between terminal +B and HT.
Resistance: 11 - 16 Ω at 20°C (68°F)
If the resistance is not as specified, replace the sensor.
Torque:
- 44 N.m (450 kgf.cm, 32 ft.lbf) for sensor 1
- 20 N.m (200 kgf.cm, 14 ft.lbf) for sensor 2
- Reconnect the oxygen sensor connector.
- INSPECT OPERATION OF HEATED OXYGEN SENSORS (See DTC P0130, P0150, P2195, P2196, P2197, P2198: OXYGEN SENSOR CIRCUIT (BANK 1 SENSOR 1), OXYGEN SENSOR SIGNAL STACK LEAN/RICH (BANK 1 & 2 SENSOR 1) and DTC P0136, P0156: OXYGEN SENSOR CIRCUIT MALFUNCTION (BANK 1 & 2 SENSOR 2) )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.