Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE
Fuel Pump Resistor: Inspection
- REMOVE FUEL PUMP RESISTOR
- INSPECT FUEL PUMP RESISTOR
Using an ohmmeter, measure the resistance between the terminals.
Resistance: 0.70 - 0.76 Ω at 20°C (68°F)
If the resistance is not as specified, replace the resistor.
- REINSTALL FUEL PUMP RESISTOR
Torque: 12 N.m (122 kgf.cm, 8.8 ft.lbf)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.