Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2005 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE

Fuel Pressure Regulator: Installation

INSTALL FUEL PRESSURE REGULATOR
1. Apply a light coat of gasoline to a new O-ring, and install it to the fuel pressure regulator.
2. While turning the fuel pressure regulator left and right, install it to the delivery pipe.
  
  Fig 1: Installing Fuel Pressure Regulator Left & Right
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the fuel pressure regulator with the 2 bolts.
  Torque: 7.5 N.m (80 kgf.cm, 66 in.lbf)
4. Connect the vacuum sensing hose to the fuel pressure regulator.
5. Connect the fuel return hose to the pressure regulator.
CHECK FOR FUEL LEAKS (See SFI SYSTEM )
INSTALL V-BANK COVER

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.