Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE
Service Data
SERVICE SPECIFICATIONS TABLE - CHARGING
| Battery | Specific gravity | at 20Β°C (68Β°F) | 1.25 to 1.29 |
| Voltage | at 20Β°C (68Β°F) | 12.5 to 12.9 V | |
| Generator | Rated output | Β | 12V 130A |
| Rotor coil resistance | at 20Β°C (68Β°F) | 2.3 to 2.7 Ξ© | |
| Slip ring diameter | STD | 14.2 to 14.4 mm (0.559 to 0.567 in.) | |
| Brush exposed length | STD | 10.5 mm (0.413 in.) | |
| Minimum | 4.5 mm (0.177 in.) | ||
| Charging circuit | Without load | STD amperage | 10 A or less |
| STD voltage | 13.2 to 14.8 V | ||
| With load | STD amperage | 30 A or less |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.