Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota ECHO 2D Sedan, StandardFACTORY OEM SERVICE PROCEDURE
Engine Control System (SFI): Injector: Installation
- INSTALL INJECTORS AND DELIVERY PIPES
- Install a new grommet to each injector.
- Apply a light coat of spindle oil or gasoline to new O-ring and install them to each injector.
- Apply a light coat of spindle oil or gasoline on the area where the delivery pipe touches the O-ring.
- While turning the injector clockwise and counterclockwise, push it into the delivery pipes. Install the 4 injectors.
- Position the injector connector outward.
- Place the 2 spacers in position on the cylinder head.
- Apply a light coat of spindle oil or gasoline on the area where the cylinder head touches the injector grommet.
- Place the delivery pipe and fuel pipe together with the 4 injectors in position on the cylinder head.
- Temporarily install the 2 bolts holding the delivery pipe to the cylinder head.
- Temporarily install the bolt holding the fuel pipe to the cylinder head.
- Check that the injectors rotate smoothly.NOTE: If the injectors do not rotate smoothly, the probable cause is incorrect installation of the O-ring. Replace the O-ring.
- Position the injector connector outward.
- Tighten the 2 bolts holding the delivery pipe to the cylinder head.
Torque: 19 N.m (190 kgf.cm, 14 ft.lbf)
- Tighten the bolt holding the fuel pipe to the cylinder head.
Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)
- CONNECT FUEL TUBE
- Connect the fuel tube (fuel tube connector) to the fuel pipe.CAUTION: Perform connecting operations of the connector (quick type) after observing the precautions.
- Install the fuel pipe clamp.
- Connect the fuel tube (fuel tube connector) to the fuel pipe.
- INSTALL WIRE HARNESS PROTECTOR COVER
- Install the wire harness protector cover with the bolt and the 2 nuts.
- Connect the PCV hose to the cylinder head cover.
- CONNECT HIGH-TENSION CORDS
Connect high-tension cords to ignition coils.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
