2005 Toyota ECHO 2D Sedan, StandardFACTORY OEM SERVICE PROCEDURE

Engine Control Module (ECM): Inspection

  1. REMOVE ECM 
    1. Remove the glove compartment door (See REMOVAL ).
    2. Remove the connector cover.
    3. Remove the 2 screws and ECM.
    4. Disconnect the ECM connectors.
  2. INSPECT ECM (See  TERMINALS OF ECM  ) 
  3. REINSTALL ECM 
    1. Connect the 3 ECM connectors.
    2. Install the ECM with the 2 screws.
    3. Install the connector cover.
    4. Install the glove compartment door (See INSTALLATION ).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.