Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSTOYOTA2005CELICA GT-S, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSSFI SYSTEMFUEL PUMPINSTALLATION

2005 Toyota Celica GT-S, Standard

Fuel Pump: Installation

2005 Toyota Celica GT-S, StandardSECTION Installation

INSTALL FUEL PUMP ASSEMBLY
1. Install the new gasket to the fuel pump assembly.
2. Install the fuel pump assembly to the fuel tank.
  NOTE:
  - Do not damage the fuel pump filter.
  - Be careful that the arm of the sender gauge should not bent.
3. Install the 8 bolts and fuel tank vent tube set plate from the fuel tank.
  Torque: 4.0 N.m (40 kgf.cm, 35 in..lbf)
Fig 1: Installing Fuel Pump Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FUEL TUBE
1. Clean up around the fuel tube.
2. Connect the fuel tube and emission tube to the fuel pump assembly.
3. Connect the tube joint clip to the fuel suction plate.
Fig 2: Connecting Fuel Tube
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT FUEL PUMP AND SENDER GAUGE CONNECTOR AND VAPOR PRESSURE SENSOR CONNECTOR
HINT:

Start the engine, check for fuel leakage.
INSTALL FLOOR SERVICE HOLE COVER
1. Install the service hole cover.
2. Install the floor carpet.
INSTALL REAR SEAT CUSHION

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.