Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2005CELICA GT-S, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSSFI SYSTEMCIRCUIT OPENING RELAYINSPECTION
2005 Toyota Celica GT-S, Standard
Circuit Opening Relay: Inspection
2005 Toyota Celica GT-S, StandardSECTION Inspection
- REMOVE CIRCUIT OPENING RELAY
- INSPECT CIRCUIT OPENING RELAY CONTINUITY
- Using an ohmmeter, check that there is continuity between terminals 1 and 2.
If there is no continuity, replace the relay.
- Check that there is no continuity between terminals 3 and 5.
If there is continuity, replace the relay.
- Using an ohmmeter, check that there is continuity between terminals 1 and 2.
- INSPECT CIRCUIT OPENING RELAY OPERATION
- Apply battery voltage across terminals 1 and 2.
- Using an ohmmeter, check that there is continuity between terminals 3 and 5.
If there is no continuity, replace the relay.
- REINSTALL CIRCUIT OPENING RELAY
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.