Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
Unless the driver's door is opened then closed within 43 seconds after the ignition switch is turned from ON to OFF, the instrument panel J/B (body ECU) supplies the power source to the master switch.
HINT:
If a malfunction is detected in the jam protection pulse sensor and limit switch, the operation after the ignition switch is turned OFF will be prohibited by the fail-safe function. At this time, the AUTO UP and DOWN operations will be prohibited, as well.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
