Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota Camry Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Terminals Of Ecu
- CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSY
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- Disconnect the D12 master switch connector and check the voltage and continuity of each terminal of the wire harness side connector.
Standard:
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
If the result is not as specified, there may be a malfunction on the wire harness side.
- Reconnect the D12 master switch connector, and check the voltage of each terminal of the connector.
Standard:
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
If the result is not as specified, the master switch may be defective.
- Check the illumination.
- When the ignition switch is turned to ON from OFF with the connector connected, check that the illumination (LED) AUTO will light up.
- Disconnect the D12 master switch connector and check the voltage and continuity of each terminal of the wire harness side connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
