Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE
Push Button Start DTCS
PUSH BUTTON START DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| B2271 | IGNITION HOLD MONITOR MALFUNCTION |
| B2272 | IGNITION 1 OUTSIDE-MONITOR MALFUNCTION |
| B2273 | IGNITION 2 OUTSIDE-MONITOR MALFUNCTION |
| B2274 | ACC MONITOR MALFUNCTION |
| B2275 | STSW MONITOR MALFUNCTION |
| B2276 | ACCR CIRCUIT DOES NOT MATCH TO STR MONITOR |
| B2277 | DETECTING VEHICLE SUBMERSION |
| B2278 | MAIN SWITCH MALFUNCTION (STARTER SWITCH 1 SIGNAL DOES NOT MATCH TO STARTER SWITCH 2 SIGNAL) |
| B2281 | P SIGNAL MALFUNCTION (CABLE INFORMATION DOES NOT MATCH TO BEAN-INFORMATION) |
| B2282, B2283 | VEHICLE SPEED SIGNAL MALFUNCTION (CABLE INFORMATION DOES NOT MATCH BEAN-INFORMATION) |
| B2284 | BRAKE SIGNAL MALFUNCTION (CABLE INFORMATION DOES NOT MATCH BEAN INFORMATION) |
| B2285 | STEERING LOCK POSITION SIGNAL MALFUNCTION (CABLE-INFORMATION DOES NOT MATCH TO LIN-INFORMATION) |
| B2288 | STEERING LOCK UNLOCK WAITING TIME OVER |
| B2286 | RUNABLE SIGNAL MALFUNCTION (CABLE-INFORMATION DOES NOT MATCH TO BEAN-INFORMATION) |
| B2287 | LIN COMMUNICATION MASTER MALFUNCTION |
| B2289 | KEY COLLATION WAITING TIME OVER |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.