2005 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE

Typical Enabling Conditions

TYPICAL ENABLING CONDITIONS

Monitor runs whenever these DTCs not present See LIST OF DISABLE A MONITORΒ 
EVAP key-off monitor runs when all of following conditions met -
Atmospheric pressure 525 to 825 mmHg (70 to 110 kPa)
Battery voltage 10.5 V or more
Vehicle speed Below 2.5 mph (4 km/h)
Ignition switch OFF
Engine condition Not running
FTP sensor malfunction (P0450, P0451, P0452 and/or P0453) Not detected
Purge VSV Not operated by scan tool
Vent valve Not operated by scan tool
Leak detection pump Not operated by scan tool
Both of following conditions met before IG switch OFF Conditions 1 and 2
1. Duration that vehicle driven 5 minutes or more
2. Purge flow Executed
ECT 4.4 to 35Β°C (40 to 95Β°F)
IAT 4.4 to 35Β°C (40 to 95Β°F)
Time after engine stopped 5 hours

Example of restart time

RESTART TIME

First time 7 hours
Second time 9 hours and 30 minutes
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.