Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE
Engine Fuel System: Inspection
- INSPECT FUEL INJECTOR ASSY
- Inspect injector resistance.
- Using an ohmmeter, measure the resistance between the terminals.
Resistance: 11.6 to 12.4 Ω at 20°C (68°F)
If the resistance is not as specified, replace the injector.
- Using an ohmmeter, measure the resistance between the terminals.
- Inspect the injection volume.CAUTION: This test involves high - pressure fuel and electricity. Take every precaution regarding safe handling of both the fuel and the electricity. Perform this test in a safe area, and avoid any sparks or flames. Do not smoke.
- Install the fuel tube connector to SST (hose), then connect the tube connector to the fuel pipe (vehicle side).
SST 09268-41048 (95336-08070, 09268-41500)
- Install the O-ring to the fuel injector.
- Connect SST (adaptor and hose) to the injector, and hold the injector and union with SST (clamp).
SST 09268-41048 (09268-41130, 90467-13001), 09268-41400
- Put the injector into the graduated cylinder.CAUTION: Install a suitable vinyl tube onto the injector to contain gasoline spray.
- Install the fuel tube connector to SST (hose), then connect the tube connector to the fuel pipe (vehicle side).
- Inspect injector resistance.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
