Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Toyota Avalon LimitedFACTORY OEM SERVICE PROCEDURE
Power Window Control System: Initialization
NOTE:
If the jam protection function does not function properly, perform the following procedures.
- Ignition switch on (IG).
- (Power window can be partially or fully open.)
- Close the power window by holding the Auto UP knob ON.
- Continue to hold the Auto UP knob ON a minimum of 1 second after the power window completely closes.
- Release the Auto UP knob.
HINT:
Front passenger must be initialized from actual multiplex network switch assy. After initialization operation (from the multiplex network master switch assy to the multiplex network switch assy) will be allowed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.