Basic Inspection

When the malfunction is not confirmed in the DTC check, troubleshooting should be carried out in all the possible circuits considered as causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location causing the problem can be found quickly and efficiently. Therefore, using this check is essential in the engine troubleshooting.

1. CHECK BATTERY POSITIVE VOLTAGE 
   NOTE: Carry out this check with the engine stopped and ignition switch OFF.
   CHECK BATTERY POSITIVE VOLTAGE
   
   

   	OK	NG
   Voltage	11 V or more	Less than 11 V

   1. NG: CHARGE OR REPLACE BATTERY 
   2. OK: GO TO NEXT STEP 
2. CHECK IF ENGINE IS CRANKED 
   1. NG: PROCEED TO  PROBLEM SYMPTOMS TABLE  
   2. OK: GO TO NEXT STEP 
3. CHECK IF ENGINE STARTS 
   1. NG: GO TO STEP   6 
4. CHECK AIR FILTER 
   1. Visually check that the air filter is not excessively dirty or oily.
   1. NG: REPLACE AIR FILTER 
   2. OK: GO TO NEXT STEP 
5. CHECK IDLE SPEED (See  ENGINE (2UZ-FE)  ) 
   1. NG: PROCEED TO  PROBLEM SYMPTOMS TABLE  
   2. OK: GO TO NEXT STEP 
6. CHECK FUEL PRESSURE (See  ON-VEHICLE INSPECTION  ) 
   1. NG: PROCEED TO  ON-VEHICLE INSPECTION  AND CONTINUE TO TROUBLESHOOTING 
   2. OK: GO TO NEXT STEP 
7. CHECK FOR SPARK (See  IGNITION SYSTEM (2UZ-FE)  ) 
   1. NG: PROCEED TO  IGNITION SYSTEM (2UZ-FE)  AND CONTINUE TO TROUBLESHOOTING 
   2. OK: GO TO NEXT STEP 

   PROCEED TO  PROBLEM SYMPTOMS TABLE