2004 Toyota RAV4 L, FWD, AutomaticFACTORY OEM SERVICE PROCEDURE

SFI System: Injector: Installation

  1. INSTALL INJECTORS AND DELIVERY PIPES 
    1. Apply a light coat of spindle oil or gasoline to a new O-ring, and install it to each injector.
      Fig 1: Applying Light Coat Of Spindle Oil Or Gasoline To O-Ring
      G02639425Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the 2 spacers and 4 new grommets to the cylinder head.
      Fig 2: Installing Spacers And Grommets To Cylinder Head
      G02639426Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Apply a light coat of spindle oil or gasoline to the place where a delivery pipe touches the O-ring.
    4. Push the injector to the delivery pipes turning the injector as shown in Fig 3. Then install the 4 injectors.
    5. Position the injector connector downward.
      Fig 3: Pushing Injector To Delivery Pipes & Positioning Injector Connector Downward
      G02639427Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Attach the delivery pipe together with the 4 injectors to the cylinder head.
    7. Temporarily install the 2 bolts holding the delivery pipe to the cylinder head.
      Fig 4: Installing Bolts Holding Delivery Pipe To Cylinder Head
      G02639428Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Check that the injectors rotate smoothly.

      HINT:

      If injectors do not rotate smoothly, the possible cause is incorrect installation of the O-ring. Replace the O-ring.

    9. Position the injector connector downward.
      Fig 5: Checking Injectors Rotate Smoothly & Positioning Injector Connector Downward
      G02639429Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    10. Tighten the 2 bolts holding the delivery pipe to the cylinder head.

      Torque: 20 N.m (205 kgf.cm, 15 ft.lbf) 

      11. Fig 6: Tightening Bolts Holding Delivery Pipe To Cylinder Head
      G02639430Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    11. Connect the 4 injector connectors.
  2. INSTALL AIR CLEANER ASSEMBLY WITH MAF METER 
  3. CONNECT PCV HOSE 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.