Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Toyota RAV4 Base, FWD, AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Starter Mounting Bolt | 27 (37) |
| Terminal Nuts | 13 (17) |
| INCH Lbs. (N.m) | |
| Clutch Housing Screws | 52 (5.9) |
| End Cover Bolts | 26 (3) |
| Field Frame Screws | 13 (1.5) |
| Magnetic Switch End Cover Bolts | 23 (2.5) |
| Starter Through Bolt | 52 (5.9) |
| Starter Wire Nut | 78 (8.8) |
| Terminal "C" Nut | 52 (5.9) |
| Through Bolts | 52 (5.9) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.