Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Toyota PriusFACTORY OEM SERVICE PROCEDURE
Power Steering DTCS
POWER STEERING DIAGNOSTIC TROUBLE CODES (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| C1511, C1512, C1513, C1514, C1517 | Torque sensor malfunction |
| C1524 | Motor malfunction |
| C1531, C1532 | Power steering ECU malfunction |
| C1533 | Temperature sensor malfunction in power steering ECU |
| C1551 | IG power source voltage error |
| C1552 | PIG power source voltage error |
| C1554 | Power source relay malfunction |
| C1555 | Motor relay malfunction |
| U0073 | CAN bus malfunction |
| U0121 | ABS (ECB) ECU communication error |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
