2004 Toyota PriusFACTORY OEM SERVICE PROCEDURE

Service Data

Fuel Service Data Specification

Fuel pressure at idle 304 to 343 kPa (3.1 to 3.5 kgf/cm2 , 44 to 50 psi)
  5 minutes after the engine has stopped 147 kPa (1.5 kgf/cm2 , 21 psi) or more
Fuel injector assy    
Resistance 1 - 2 13.45 to 14.15 Ω at 21°C (68°F)
Injection volume Standard 36 to 46 cm3 (2.1 to 2.8 cu in.)
  Difference between each fuel injector 10 cm3 (0.6 cu in.) or less
Leakage Standard 1 drop or less per 12 minutes
Fuel tank assy (fuel pump)    
Resistance 3 - 7 0.2 to 3.0 Ω at 20°C (68°F)
Compression spring (Exhaust pipe assy front x Exhaust manifold)    
Free length Minimum 40.5 mm (1.594 in.)
Compression spring (Exhaust pipe assy front x Exhaust pipe assy tail)    
Free length Minimum 38.5 mm (1.516 in.)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.