2004 Toyota PriusFACTORY OEM SERVICE PROCEDURE

Torque Specification

STARTING OR CHARGING TORQUE SPECIFICATION

Part Tightened N.m kgf.cm ft.lbf
Battery hold down clamp x Body 5.4 55 48 in..lbf
Battery hold down clamp x Battery tray 5.4 55 48 in..lbf
Fusible link block assy x Battery 6.0 61 53 in..lbf
Quarter vent duct No. 2 x Body 4.0 41 35 in..lbf
Engine wire No. 3 (battery negative terminal) x Battery 6.0 61 53 in..lbf
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.