Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Driver Window DOWN Operation
With power window motor 6-pin electrical harness connector disconnected, connect ohmmeter positive lead to terminal No. 4 and ohmmeter negative lead to terminal No. 5 of power window motor. Apply battery positive voltage to terminal No. 2 and battery negative voltage to terminal No. 1 of power window motor. See STEP 2 in illustration. See Fig 1. Ensure continuity exists when window goes down, and does not exist when window is fully opened. If continuity is not as specified, replace power window motor. See POWER WINDOW MOTOR under REMOVAL & INSTALLATION.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.