Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 185 (BODY CONTROL SYSTEM)COMPONENT TESTSSTOP LIGHT SWITCH
2004 Toyota Matrix XR, FWD, Standard
Stop Light Switch
2004 Toyota Matrix XR, FWD, StandardSECTION Stop Light Switch
WARNING: This page is about a different car, the 2002 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.
Inspect the stop light switch continuity. See CONNECTOR IDENTIFICATION . See INSPECTING STOP LIGHT SWITCH CONTINUITY table. If continuity is not as specified, replace the switch.
INSPECTING STOP LIGHT SWITCH CONTINUITY
| Switch Position | Tester Connection | Specified Condition |
|---|---|---|
| Switch Pin Free | 1 - 2 | Continuity |
| Switch Pin Pushed In | 3 - 4 | Continuity |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.