Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE
Speedometer Sensor (A246E): Replacement
- REMOVE AIR CLEANER CASE
- REMOVE AIR CLEANER HOSE NO.1
- REMOVE SPEEDOMETER SENSOR
- Disconnect the connector.
- Remove the bolt and speedometer sensor assembly.
- Remove the clip and driven gear from the speedometer sensor.
- INSTALL SPEEDOMETER SENSOR
- Coat a O-ring with ATF and install it to the speedometer sensor.
- Install the driven gear to the speedometer sensor with the clip.
- Install the speedometer sensor assembly with the bolt.
- Torque: 11.3 N.m (115 kgf.cm, 9 ft.lbf)
- Connect the connector.
- INSTALL AIR CLEANER HOSE NO.1
- INSTALL AIR CLEANER CASE
- Torque: 7.0 N.m (71 kgf.cm, 62 in.lbf)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
