2004 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE

Optical Sensor: Removal

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the liftgate.
  2. Disconnect and isolate the negative battery cable.
  3. Remove the left rear D-pillar trim panel from the vehicle. Refer to D-PILLAR TRIM .
    CAUTION: Locate the wires coming from the optical sensor. On a piece of paper, note the wire location and cavity the wires are currently installed in on both the sensor and connector side of the harness. This will prove helpful later.
  4. Cut the wires leading to the optical sensor and back the wires out of the drive unit's main electrical connector. Refer to SYSTEM WIRING DIAGRAMS .
    Fig 1: Removing Optical Sensor
    G03572380Courtesy of DAIMLERCHRYSLER CORP.
  5. Using a small flat-bladed tool, depress one of the optical sensor's plastic retaining tabs (Fig 1) to unhook the optical sensor from the clutch housing assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.