2004 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE

Link Rod: Operation

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.

One end of the link rod assembly is attached to the liftgate, the other attached to the lift rack of the drive unit. When the lift rack is driven by the liftgate motor assembly the liftgate is moved to the open or closed position.

Fig 1: Identifying Link Rod
G03572377Courtesy of DAIMLERCHRYSLER CORP.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.