2004 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE

Liftgate Is Open

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.

Depressing either of the power liftgate open/close command switches, sends a PCI data bus signal to the power liftgate control module. The control module will then signal the liftgate motor to move the liftgate into the closed position. Once the door mounted latch reaches the body mounted striker assembly, the power latch takes over to cinch the door to the fully closed and latched position.

If a obstacle is encountered during a power open or close cycle, the power liftgate control module will automatically reverse direction of the liftgate to prevent vehicle damage or personal injury. Refer to the owner's manual for additional information.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.