2004 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE

Controller Antilock Brake: Removal

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative (-) battery cable from battery post and isolate.
  2. Raise and support vehicle.
  3. Remove 3 screws attaching CAB to HCU (Fig 1).
    Fig 1: Removing Controller Antilock Brake
    G03571414Courtesy of DAIMLERCHRYSLER CORP.
  4. Slide CAB off HCU (Figure).
  5. Disconnect 47-way wiring connector at CAB (Figure).
  6. Remove CAB.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.