Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE
Torque Specification
WARNING: This page is about a different car, the 2004 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
SFI TORQUE SPECIFICATIONS
| Part tightened | N.m | kgf.cm | ft.lbf |
|---|---|---|---|
| Fuel tank vent tube set plate x Fuel tank | 3.4 | 35 | 30 in.lbf |
| Air cleaner inlet x Body | 5.0 | 55 | 48 in.lbf |
| Air cleaner assembly x Air cleaner bracket | 5.0 | 55 | 48 in.lbf |
| Air cleaner assembly x Cylinder head cover | 5.0 | 55 | 48 in.lbf |
| Delivery pipe x Cylinder head | 20 | 205 | 15 |
| Fuel pressure pulsation damper x Delivery pipe | 9 | 90 | 80 in.lbf |
| Fuel tank band x Body | 40 | 410 | 29 |
| Fuel tank protector x Fuel tank | 5.5 | 56 | 49 in.lbf |
| Fuel sender gauge x Fuel tank | 1.5 | 15 | 13 in.lbf |
| Fuel pump and sender gauge assembly x Fuel tank | 4.0 | 40 | 35 in.lbf |
| Throttle body x Intake manifold | 30 | 305 | 22 |
| Camshaft timing OCV x Cylinder head | 9.0 | 90 | 80 in.lbf |
| VSV for CCV x Body | 9.0 | 90 | 80 in.lbf |
| Charcoal canister protector x Body | 5.0 | 50 | 44 in.lbf |
| Engine coolant temperature sensor x Cylinder head | 20 | 200 | 15 |
| Intake manifold x Cylinder head | 30 | 305 | 22 |
| Knock sensor x Cylinder block | 20 | 204 | 15 |
| A/F sensor x Exhaust manifold | 44 | 450 | 33 |
| Heated Oxygen sensor x Exhaust manifold | 44 | 450 | 33 |
| Accelerator pedal assembly x Body | 5.4 | 55 | 48 in.lbf |
| ECM bracket x Body | 9.0 | 90 | 80 in.lbf |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.