2004 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE

Input Shaft: Disassembly

WARNING: This page is about a different car, the 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove planetary sun gear from input shaft  .
    Fig 1: Identifying Sun Gear & Input Shaft
    G01066111Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Remove needle roller bearing and bearing race  :

    Using a screwdriver, remove the needle roller bearing and 2 bearing races. See Figure.

    Fig 2: Removing Needle Bearing & Race
    G01066112Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.