Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Overdrive Control Function
During cruise control driving, the overdrive may be cut on an uphill grade. After the overdrive is cut, if the vehicle speed reaches the overdrive resume speed (set speed minus 1.2 mph, 2 km/h), and if the system determines that the uphill grade has finished, the overdrive will resume after overdrive resume timer operation. However, if the actual vehicle speed becomes slower than the overdrive resume speed before the timer operation has finished, the timer will be reset, and will start again when the vehicle speed reaches the overdrive resume speed.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
