2004 Toyota Land CruiserFACTORY OEM SERVICE PROCEDURE

Circuit Protection Devices

CIRCUIT PROTECTION DEVICES LOCATION

Component Location
Cowl Side J/B LH Left kick panel. See Figure.
Cowl Side J/B RH Right kick panel. See Figure.
Engine Room J/B On left inner fender panel. See Figure.
Engine Room R/B Left front of engine compartment. See Figure.
Fusible Link Block On left side of engine compartment, near battery. See Figure.
J/B No. 4 Behind center of dash. See Figure.
J/B No. 5 Behind instrument cluster. See Figure.
J/B No. 6 Behind right side of dash. See Figure.
J/B No. 7 Behind right side of dash. See Figure.
Overhead J/B In front center of roof. See Figure.
Rear Cooler Power Transistor Right rear of cargo area. See Figure.
Rear Heater Power Transistor On left "C" pillar. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.