Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE
Ignition Coil: Replacement
- REMOVE V-BANK COVER
- Using a 5 mm hexagon wrench, remove the 3 cap nuts.
- Loosen the V-bank cover fastener counterclockwise.
- Remove the V-bank cover.
- REMOVE IGNITION COILS
- Disconnect the 6 ignition coil connectors.
- Remove the bolt, and pull out the ignition coil. Remove the 6 ignition coils.
- REINSTALL NEW IGNITION COILS
- Connect a new ignition coil to the spark plug, and attach the ignition coil to the cylinder head cover, and install the bolt. Install the 6 ignition coils.
Torque: 8 N.m (80 kgf.cm, 69 in.lbf)
- Connect the 6 ignition coil connectors.
- Connect a new ignition coil to the spark plug, and attach the ignition coil to the cylinder head cover, and install the bolt. Install the 6 ignition coils.
- REINSTALL V-BANK COVER
- Using 5 mm hexagon wrench, install the V-bank cover with the 3 cap nuts.
- Press down the V-bank cover fastener.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
