2004 Toyota Avalon XLSFACTORY OEM SERVICE PROCEDURE

Mass Air Flow (MAF) Meter: Inspection

  1. INSPECT MAF METER RESISTANCE 

    Using an ohmmeter, measure the resistance between terminals THA and E2.

    Resistance: 

    RESISTANCE CHECK

    Terminals Resistance Temperature
    THA - E2 13.6 - 18.4 kΩ -20°C (-4°F)
    THA - E2 2.21 - 2.69 kΩ 20°C (68°F)
    THA - E2 0.49 - 0.6 kΩ 60°C (140°F)
    Fig 1: Inspecting MAF Meter Resistance
    G02878940Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    If the resistance is not as specified, replace the MAF meter.

  2. INSPECT MAF METER OPERATION 
    1. Connect the MAF meter connector.
    2. Turn the ignition switch ON.
    3. Using a voltmeter, connect the positive (+) tester probe to terminal VG, and negative (-) tester probe to terminal E2G.
    4. Blow air into the MAF meter, and check that the voltage fluctuates.

      If operation is not as specified, replace the MAF meter.

    5. Turn the ignition switch LOCK.
    6. Disconnect the MAF meter connector.
    Fig 2: Inspecting MAF Meter Operation
    G02878941Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.