Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Toyota RAV4 Base, AWD, AutomaticFACTORY OEM SERVICE PROCEDURE
Body & Frame: Windows: Windshield: Removal
- REMOVE INNER REAR VIEW MIRRORÂ
- REMOVE ROOF CONSOLE BOXÂ
- Using a screwdriver, remove roof console box cover.NOTE: Tape the screwdriver tip before use.
- Remove the 3 screws and roof console box, then disconnect the connector.
- Using a screwdriver, remove roof console box cover.
- REMOVE SUN VISORS AND HOLDERSÂ
- Remove the 4 screws and 2 sun visors.
- Remove the 2 holders.
- REMOVE FRONT PILLAR GARNISHESÂ
- REMOVE WIPER ARMSÂ
- REMOVE COWL TOP VENTILATOR LOUVER AND HOOD TO COWL TOP SEALÂ
- REMOVE WINDSHIELD OUTSIDE MOULDINGÂ
- REMOVE WINDSHIELD MOULDINGÂ
- Using a knife, cut off the moulding as shown in the illustration.NOTE: Do not damage the body with the knife.
- Remove the remaining moulding.
- Using a knife, cut off the moulding as shown in the illustration.
- REMOVE WINDSHIELD GLASSÂ
- Push a piano wire through between the body and glass from the interior.
- Tie both wire ends to wooden blocks or similar objects.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
