Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Toyota PriusFACTORY OEM SERVICE PROCEDURE
Converter And Inverter Assembly: Reassembly
- INSTALL WATER HOSE
- INSTALL BRACKET
Install the 4 brackets with the 6 bolts.
Torque: 25 N.m (255 kgf.cm, 18 ft.lbf)
- INSTALL INVERTER COVER
- Install a new gasket to the inverter cover.
- Install the inverter cover with the 12 bolts.
Torque: 2.5 N.m (25 kgf.cm, 22 in.lbf)
- INSTALL INVERTER RESERVOIR TANK
- Install a new O-ring to the inverter reservoir tank.
- Install the inverter reservoir tank with the 2 bolts and nuts.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
