2003 Toyota PriusFACTORY OEM SERVICE PROCEDURE

Anti-Lock Brake System: Description

CAUTION: See ANTI-LOCK BRAKE SAFETY PRECAUTIONS article in GENERAL INFORMATION.

Anti-Lock Brake System (ABS) consists of hydraulic unit, actuator, solenoids, pump motor, ABS Electronic Control Unit (ECU), relays and wheel speed sensors. See Fig 1. An ABS warning light and Brake warning light are located in instrument cluster. ABS ECU performs a bulb test by illuminating ABS warning light and Brake warning light for 3 seconds when ignition is turned ON. A primary check is performed after each engine start, and when initial vehicle speed exceeds 6 mph. Under normal operation, an actuator noise is heard as vehicle is started or as speed exceeds 6 mph. Anti-lock system remains active until vehicle speed drops to less than 3 mph.

Fig 1: Identifying ABS System Components
G00203165Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.