Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Seat Belt: Inspection
- INSPECT FRONT SEAT INNER BELT ASSY LH
- Inspect the buckle switch.
- Fasten the seat belt (buckle switch ON).
- Inspect the continuity and resistance between the terminals, as shown in the illustration and table.
Standard:
- Release the seat belt (buckle switch OFF).
- Inspect the continuity and resistance between the terminals, as shown in the illustration and table.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Standard:
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
If the result is not as specified, replace the inner belt.
- Inspect the circuit for the airbag seat position sensor.
- Inspect the continuity between the B7 connector and connector for the airbag seat position sensor, as shown in the illustration and table.
Standard:
If the result is not as specified, replace the inner belt.
- Inspect the buckle switch.
- INSPECT FRONT SEAT INNER BELT ASSY RH
- Inspect the buckle switch.
- Fasten the seat belt (buckle switch ON).
- Inspect the continuity between terminals B8-1 and B8-2, as shown in the illustration.
Standard: No continuity
- Release the seat belt (buckle switch OFF).
- Inspect the continuity between terminals B8-1 and B8-2, as shown in the illustration.
Standard: Continuity
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
If the result is not as specified, replace the inner belt.
- Inspect the circuit for the occupant detection sensor.
- Connect the connector terminals 1 and 2 for the occupant detection sensor.
- Inspect the continuity between terminals B8-3 and B8-4, as shown in the illustration.
Standard: Continuity
If the result is not as specified, replace the inner belt.
- Inspect the buckle switch.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
