2003 Toyota Matrix Base, FWD, AutomaticFACTORY OEM SERVICE PROCEDURE

Service Data

Lubrication System Service Specifications (1ZZ-FE)

Oil pressure at idle speed 29 kPa (0.3 kgf.cm2 , 4.2 psi) or more
at 3,000 r/min 294 - 539 kPa (3.0 - 5.5 kgf.cm2 , 43 - 78 psi) or more
Adhesive Part No. 08833 - 00080, THREE BOND 1344, LOCTITE 242, or equivalent
Engine oil  
Capacity Drain and refill w/ oil filter change 3.7 liters (3.9 US qts, 3.3 lmp. qts)
Drain and refill w/o oil filter change 3.5 liters (3.7 US qts, 3.1 lmp. qts)
Dry fill 4.2 liters (4.4 US qts, 3.7 lmp. qts)
Oil pump assy  
Tip clearance 0.040 - 0.160 mm (0.0016 - 0.0063 in.)
Body clearance 0.260 - 0.325 mm (0.0102 - 0.0128 in.)
Side clearance 0.025 - 0.071 mm (0.0010 - 0.0028 in.)
Lubrication System Service Specifications (2ZZ-GE)

Oil pressure    
at idle speed 19.2 kPa (0.2 kgf.cm2 , 2.8 psi) or more
at 3,000 r/min 294 - 539 kPa (3.0 - 5.5 kgf.cm2 , 43 - 78 psi) or more
Adhesive Part No. 08833 - 00080, THREE BOND 1344, LOCTITE 242, or equivalent
Engine oil  
Capacity Drain and refill w/ oil filter change 4.4 liters (4.7 US qts, 3.9 lmp. qts)
Drain and refill w/o oil filter change 4.2 liters (4.4 US qts, 3.7 lmp. qts)
Dry fill 4.8 liters (5.1 US qts, 4.2 lmp. qts)
Oil pump assy  
Tip clearance Standard 0.060 - 0.180 mm (0.0024 - 0.0071 in.)
Maximum 0.35 mm (0.0138 in.)
Body clearance Standard 0.125 - 0.180 mm (0.0049 - 0.0071 in.)
Maximum 0.325 mm (0.0128 in.)
Side clearance Standard 0.030 - 0.080 mm (0.0012 - 0.0032 in.)
Maximum 0.16 mm (0.0063 in.)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.