Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Toyota Matrix Base, FWD, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES LOCATION
| Component | Component Location |
|---|---|
| Back-Up Light Switch (Except XRS) | On left side of transaxle. See Figure. |
| Back-Up Light Switch (XRS) | On left side of transaxle. See Figure. |
| Brake Fluid Level Warning Switch | On brake fluid reservoir. See Figure. |
| Buckle Switch (Left) | In left front seat belt buckle. See Figure. |
| Buckle Switch (Right) | In right front seat belt buckle. See Figure. |
| Clutch Start Switch | On bracket, above clutch pedal. See Figure. |
| Cruise Control Clutch Switch | On bracket, above clutch pedal. See Figure. |
| Oil Pressure Switch (Except XRS) | On lower left side of engine. See Figure. |
| Oil Pressure Switch (XRS) | On lower left side of engine. See Figure. |
| Parking Brake Switch | At base of park brake lever. See Figure. |
| Park/Neutral Position Switch (Except XRS) | On left side of transaxle. See Figure. |
| Park/Neutral Position Switch (XRS) | On left side of transaxle. See Figure. |
| Power Steering Oil Pressure Switch | At right rear of engine compartment. See Figure. |
| Pressure Switch | At right side of engine compartment. See Figure. |
| Stoplight Switch | On bracket, above brake pedal. See Figure. |
| Unlock Warning Switch | On steering column, behind ignition key cylinder. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.