2003 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Bearing Cap Bolt 47 (64)
Case Plug No. 1 & 2 36 (49)
Cover No. 1 Bolt 14 (20)
Drain Plug 36 (49)
Engine Mounting Bracket RR Bolt 47 (64)
Extension Housing Bolt 19 (26)
Ring Gear Bolt 57 (78)
Stud Bolt 29 (40)
Transfer Assembly Mounting Nut 51 (69)
Transfer Stiffener Plate Center Bolt 25 (34)
Transfer Stiffener Plate RH Bolt 25 (34)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.