2003 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE

Service Specifications

SPECIFICATIONS

Application Specification
Compressor Type (1)
Compressor Belt Tension (2)
Compressor Oil Capacity (3) 4.1 ozs.
Condenser Oil Capacity (3) (1)
Evaporator Oil Capacity (3) (1)
Receiver Oil Capacity (3) (1)
Refrigerant (R-134a) Capacity 16.22-18.34 ozs.
System Operating Pressures (4)
High Side 199-227 psi (14-16 kg/cm2 )
Low Side 21-36 psi (1.5-2.5 kg/cm2 )
(1) Information is not available from manufacturer.
(2) Automatic belt tensioner is used. Adjustment is not required.
(3) Use ND-OIL 8 refrigerant oil or equivalent.
(4) With ambient temperature at 86-95Β°F (30-35Β°C) at air inlet with switch in RECIRC position, engine at 2000 RPM, blower switch in HI position and temperature control dial in COOL position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.