2003 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE

Electronic Circuit Inspection Procedure

  1. BASIC INSPECTION 
    1. RESISTANCE MEASURING CONDITION OF ELECTRONIC PARTS
      1. Unless stated, all resistance is measured at an ambient temperature of 20°C (68°F). Because the resistance may be outside the specifications if measured at high temperatures immediately after the vehicle has been running, measurements should be made when the engine has cooled down.
    2. HANDLING OF CONNECTOR
      1. When removing the connector with a lock, press the connector toward the engagement and remove the lock by making the lock claw movable easily.
      2. When removing the connector, do not hold the harness, but hold the connector.
      3. Before connecting the connector, check that there are no deformation, damage and missing of the terminals.
      4. Connection of the connector with a lock should be securely done until it makes a click sound.
      5. In case of checking the connector with a Toyota electrical tester, perform it at the back side (harness side) of the connector using a mini test lead.
      Fig 1: Testing Connector Using Toyota Electrical Tester
      G02836703Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.