Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE
Cruise Control Main Switch ASSY: Replacement
WARNING: This page is about a different car, the 2004 Toyota Matrix. However, it is still accessible from the selected car via links, so may be relevant.
- DISCONNECT BATTERY NEGATIVE TERMINAL
- INSPECT PLACE FRONT WHEELS FACING STRAIGHT AHEAD
- REMOVE HORN BUTTON ASSY (See DUAL-STAGE DRIVER-SIDE AIR BAG MODULE (MATRIX) )
- REMOVE STEERING WHEEL ASSY (See OVERHAUL
)
SST 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954-05021)
- REMOVE CRUISE CONTROL MAIN SWITCH ASSY
- Remove the 2 screws and cruise control main switch assy.
- CENTER SPIRAL CABLE (See OVERHAUL )
- INSTALL STEERING WHEEL ASSY (See OVERHAUL )
- INSPECT STEERING WHEEL CENTER POINT (See OVERHAUL )
- INSPECT HORN BUTTON ASSY (See DUAL-STAGE DRIVER-SIDE AIR BAG MODULE (MATRIX) )
- INSTALL HORN BUTTON ASSY (See DUAL-STAGE DRIVER-SIDE AIR BAG MODULE (MATRIX) )
- INSPECT SRS WARNING LIGHT (See AIR BAG WARNING LIGHT CHECK )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
