2003 Toyota Matrix Base, 4WDFACTORY OEM SERVICE PROCEDURE

Fluid Capacities (Sequoia)

FLUID CAPACITIES (SEQUOIA)

Application (1) Quantity
Automatic Transmission (Toyota Genuine ATF Type T-IV) 2.1 Qts. (2.0L)
Cooling System (Includes Heater) (2)
With Front Heater Only 12.4 Qts. (11.7L)
With Front & Rear Heater 14.1 Qts. (13.4L)
Crankcase (Includes Filter) (3) 6.5 Qts. (6.2L)
Differential
Front Axle (SAE 75W-90/API GL-5 Gear Oil) 1.2 Qts. (1.1L)
Rear Axle (API GL-5 Gear Oil) (4) 3.9 Qts. (3.7L)
Power Steering Fluid (Dexron-III ATF) 0.85 Qt. (0.8L)
Transfer Case (SAE 75W-90/API GL-4 Or GL-5 Gear Oil) 1.3 Qts. (1.2L)
(1) Approximate quantity is listed.
(2) Use Toyota Long Life coolant or equivalent ethylene-glycol type coolant.
(3) Use an API SL energy conserving engine oil.
(4) Use Synthetic oil SAE 75W-140.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.