Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 338 (Engine Compression): Inspection
HINT:
If there is a lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.
- WARM UP AND STOP ENGINE
Allow the engine to warm up to the normal operating temperature.
- REMOVE SPARK PLUGS
(See ON-VEHICLE INSPECTION )
- CHECK CYLINDER COMPRESSION PRESSURE
- Insert a compression gauge into the spark plug hole.
- Fully open the throttle.
- While cranking the engine, measure the compression pressure.
HINT:
Always use a fully charged battery to obtain the engine speed at 250 RPM or more.
- Repeat steps ( a) to ( c) for each cylinder.NOTE: This measurement must be done as quickly as possible.
- Compression pressure:
- 1,324 kPa (13.5 kgf/cm 2 , 192 psi) or more
- Minimum pressure:
- 981 kPa (10.0 kgf/cm 2 , 142 psi)
- Difference between each cylinder:
- 98 kPa (1.0 kgf/cm 2 , 14 psi) or less
- If the cylinder compression in one or more cylinders is lower than the specification, pour a small amount of engine oil into the cylinder through the spark plug hole and repeat steps ( a) to ( c) for the cylinders.
- If adding oil helps the compression, chances are that the piston rings and/or cylinder bore are worn or damage.
- If the pressure stays low, a valve may be sticking or the seating is improper, or there may be leakage past the gasket.
- REINSTALL SPARK PLUGS
- (See ON-VEHICLE INSPECTION )
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
