2003 Toyota Highlander Base, 3.0 F, FWDFACTORY OEM SERVICE PROCEDURE

Section 841 (Engine Control System (Introduction)): Precaution

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

For Supplemental Restraint System (SRS) "Air Bag" and "Seat Belt Pre-Tensioner" precautions, refer to SRS AND SEAT BELT PRE-TENSIONER .

For on board diagnosis (obd) system of ecm precautions, refer to PRECAUTION FOR ON BOARD DIAGNOSIS (OBD) SYSTEM OF ECM .

For engine control system precautions, refer to PRECAUTION FOR ENGINE CONTROL SYSTEM .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.