Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Toyota Highlander Base, 3.0 F, AWDFACTORY OEM SERVICE PROCEDURE
Service Data
IGNITION SYSTEM SERVICE DATA SPECIFICATION (2AZ-FE)
| Spark Plug | |||
| Recommended Spark Plug : | |||
| DENSO | SK20R11 | ||
| NGK | IFR611 | ||
| Electrode Gap | |||
| Standard | 1.0-1.1mm (0.039-0.043 in.) | ||
| Maximum | 1.2 mm (0.047 in.) | ||
| Camshaft Position Sensor | |||
| Resistance | |||
| At Cold | 835-1400 ohm | ||
| At Hot | 1060-1645 ohm | ||
| Crank Position Sensor | |||
| Resistance | |||
| At Cold | 985-1600 ohm | ||
| At Hot | 1265-1890 ohm | ||
IGNITION SYSTEM SERVICE DATA SPECIFICATION (1MZ-FE)
| Spark Plug | |||
| Recommended Spark Plug | |||
| DENSO | SK20R11 | ||
| NGK | IFR6A11 | ||
| Electrode Gap | |||
| Standard | 1.0-1.1mm (0.039-0.043 in.) | ||
| Maximum | 1.2mm (0.047 in.) | ||
| Crank Position Sensor | |||
| Resistance | |||
| At Cold | 835-1400 ohm | ||
| At Hot | 1060-1645 ohm | ||
| Crank Position Sensor | |||
| Resistance | |||
| At Cold | 1630-2740 ohm | ||
| At Hot | 2065-3225 ohm | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
